TM 10-4610-232-12
REMOVAL - CHECK VALVE. (MODEL ROWPU-1 ONLY)
a. Remove clamp (1) clamp (2), gasket (3), and gasket (4).
b. Remove check valve (5) from system.
c. Remove spider (6), spring (7), plunger (8), and O-ring (9) from housing (10).
REPAIR - CHECK VALVE. (MODEL ROWPU-1 ONLY)
Repair is limited to replacement of damaged or defective components.
INSTALLATION - CHECK VALVE. (MODEL ROWPU-1 ONLY)
a. Install O-ring (9), plunger (8), spring (7), and spider (6) into housing (10).
b.
Place check valve (5) into position in piping system and install gasket (4), gasket (3), clamp (2), and clamp (1).
Figure 4-49. Low Pressure Piping (Sheet 8 of 8) Check Valve
(MODEL ROWPU-1 ONLY)
4-196.2 Change 7
