TM 10-4610-232-12
(1)
Remove two dust caps (1), gaskets (2) and connectors (3).
(2)
Remove two elbows (4) and nipples (5) from tee (6).
(3)
On Model WTA-060, remove _ connector (7) and plug (8) from nipple (9). On Model ROWPU-1, remove
connector (7) and cap (8).
(4)
Remove nipple (9) from tee (6). (MODEL WTA060 ONLY)
(5) On Model WTA-060, Remove dust cap (10), gasket (11) and connector (12) from pump(13). On Model
ROWPU-1, remove plug (10) and connector (1) from pump (13).
(6)
Remove dust plug (14), gasket (15) and connector (16) from pump (13).
(7)
Raise and remove valve (17), nipple (18), elbow (19) and nipple (20) from pump (13).
b. Disassembly of Motor Cable (Figure 4-102, sheet 2).
(1)
Remove two screws (21), nuts (22), lockwashers (23), washers (24) and clips (25).
(2)
Remove four screws (26), cover (27) and gasket (28) from conduit box (29).
Figure 4-102. Distribution Pump and Motor Assembly (sheet 2 of 5)
(3) Pull five sets of wires from conduit box (29). Tag and disconnect as shown in illustration (Figure 4-102, sheet
3)
(4)
Remove one screw (30, sheet 2) holding ground cable to conduit box (29).
(5)
Loosen nut (31) and slide nut (31), washer (32) and rubber bushing (33) back on cable (34).
(6)
Remove conduit nut (35) and pull cable (34) through conduit box (29).
(7)
Slide nut (31), washer (32) and bushing (33) from cable (34).
c. Disassembly of Power Box (Figure 4-102, sheet 4).
(1)
Remove four screws (38), cover (39) and gaskets (40) from power box (57).
(2)
Unscrew and remove switch knob (41), lock ring (42) and data plate (43) from cover. Switch (44) is now free
(3)
Tag and disconnect three wires (45).
(4)
Remove conduit nut (46) and remove cable (51) and adapter (47) from power box (57).
(5)
Loosen nut (48) and slide nut (48), washer (49) and bushing (50) up the cable (51)
4-306 Change 7
