TM 10-4610-232-12
a.
b.
c.
d.
e.
f.
g.
Loosen thumbscrews (1, Figure 4-103) and swing lens guard (2) away from heat lamp body (3).
Remove lens (4) by removing screws (5) and washers (6).
Remove lens guard (2) by tapping out pivot pin (7).
Remove thumbscrew bolts (8) from lens guard (2) by tapping out pivot pins (9).
Remove bulb (10) by pulling straight out and disconnecting it from bulb socket (11).
Remove bulb retaining clips (12) by removing screws (13).
Remove handle (14) by removing screws (15) and Iockwashers (16).
h. Remove cable (17) from heat lamp by cutting off boot (18) and removing socket (19) with three wires (20).
i. Remove three wires (20) from socket (19).
j. Remove bulb socket (11) by removing screws (21), nuts (22) and washers (23).
k. Remove cable socket (24) by removing screws (25).
l. Remove heat lamp body (3) from base (26) by removing angle adjustment knob (27), Iockwasher (28) and washer
(29).
Replace any damaged components.
REASSEMBLY.
a. Install heat lamp body (3) on base (26) with flat washer (29), Iockwasher (28) and angle adjustment knob (27).
b. Install cable socket (24) with screws (25).
c. Install bulb socket (11) with washers (23), nuts (22) and screws (21).
d. Connect cable (17) to heat lamp by inserting three wires (20) through new boot (18) into socket (19) and heat
shrinking boot onto heat lamp body.
e. Install handle (14) with Iockwashers (16) and screws (15).
f. Install bulb retaining clips (12) with screws (13).
g. Install bulb (10) on bulb socket (11) and press into position.
h. Install thumbscrew bolts (8) with pivot pins (9).
i. Install lens guard (2) with pivot pin (7).
j. Install lens (4) with washers (6) and screws (5).
k. Swing lens guard (2) into position and secure with thumbscrews (1).
4-312
