TM 10-4610-239-24
TM 08580B-24/3
REMOVAL. (Cont)
d.
Remove eight nuts (11), washers (12), and bolts (13).
CAUTION
Pull brake assembly straight out from trailer. Any vertical or side-to-side
movement can cause damage to splined end of camshaft.
NOTE
Cover plate (14) and tapered bushing (15) might slide off camshaft when
camshaft is pulled through camshaft bracket.
e.
Remove brake assembly (16), tapered bushing (15), and cover plate (14) from axle (17) and
camshaft bracket (18).
INSTALLATION.
a.
Position cover plate (14) and tapered bushing (15) on camshaft (6).
CAUTION
Guide camshaft into camshaft bracket. If camshaft does not enter straight,
splined end can be damaged.
b.
Position brake assembly (16) on axle (17), guiding camshaft (6) through camshaft bracket (18).
c.
Install eight bolts (13), washers (12), and nuts (11).
d.
Position two tapered bushings (10) and (15) and two cover plates (9) and (14) on camshaft
against camshaft bracket (18). Align four holes in cover plates with four holes in camshaft
bracket.
e.
Install four bolts (8) and nuts (7).
NOTE
If hole in slack adjuster arm does not align with holes in clevis, adjust
brake. Refer to paragraph 2-73.
f.
Position slack adjuster (3) on camshaft (6) with hole in slack adjuster arm aligned with holes in clevis (4).
g.
Install lockring (5).
h.
Install clevis pin (2) and cotter pin (1).
i.
Adjust service brakes. Refer to paragraph 2-73.
2-148
