TM 10-4610-239-24
TM 08580B-24/3
INSTALLATION.
CAUTION
Pipe section (28) can be badly damaged by corrosion if it is installed in
contact with frame or clamps. Ensure Nomex tape separates pipe section
from frame and clamp.
a.
Position pipe section (28) and install two tapes (33) and clamps (32), four screws (30), eight
washers (31), and four nuts (29).
b.
Position pipe section (23) and install two gaskets (27) and clamps (26) and four bolts (25) and nuts (24).
c.
Install gasket (22) and clamp (21) and two bolts (20) and nuts (19).
d.
At output end of each of the top three R.O. pressure tubes, position pipe section (15) and install
clamp (18), bolt (17), and nut (16).
e.
Install gasket (14), clamp (13), and two bolts (12) and nuts (11).
2-165
