TM 10-4610-239-24
TM 08580B-24/3
REMOVAL. (Cont)
NOTE
Tag wires by set before removal.
c.
Pull three wire sets (6) from conduit box (7) and remove twine (8) and electrical tape (9).
d.
Remove screw (10) securing ground terminal lug (11).
NOTE
There are four sets of wires in conduit box. One motor wire is removed
from each bundle the same way. One bundle is shown.
e.
Remove nut (12), lockwasher (13), three terminal lugs (14), and flat washers (15) from screw
(16) on each set of wires (6).
f.
Install flat washer (15), terminal lugs (14), lockwasher (13), and nut (12) on screw (16).
CAUTION
Wire insulation can be damaged when wires are pulled through conduit
box. Be careful when pulling wires.
g.
Remove sealing grip (17) and gasket (18) with wires (19).
INSTALLATION.
a.
Position sealing grip (17) and gasket (18) on cable (1).
CAUTION
Wire insulation can be damaged when wires are pulled through conduit
box. Be careful when pulling wires.
b.
Pull four wires (19) from cable (1) into conduit box (7) and secure sealing grip nut (17).
NOTE
There are four sets of motor wires to connect to cable wires. Each wire from
cable is added to a motor wire wet the same way. One is shown.
c.
Remove nut (12) and lockwasher (13) from screw (16).
d.
Install terminal lugs (14) from colored wire cable (1), lockwasher (13), and nut (12) on screw (16).
2-330
