TM 10-4610-239-24
TM 08580B-24/3
3-6. REPAIR POWER CABLE ASSEMBLY.
This task covers:
a. Splice Wire.
b. Replace Connector.
INITIAL SETUP.
a.
Tools.
Tool Kit (Appx B, Sect III, Item 10).
Wire Stripper (Appx B, Sect III, Item 7).
Multimeter (Appx B, Sect III, Items 6 and 9).
Crimping Tool (Appx B, Sect III, Item 7).
b.
Materials/Parts.
Tape, Electrical (Appx C, Sect II, Item 18).
c.
Equipment Condition.
Power cable assembly removed (paragraph 2-63).
SPLICE WIRE.
NOTE
There are six wires on end of power cable assembly. Procedure is the same
to splice all six. One is shown.
a.
Cut off damaged part of wire (1). Do not discard it.
b.
Using hand wire stripper, strip end of wire stub (2).
NOTE
When crimping, be sure to make a good electrical and mechanical
connection between terminal and wire.
3-80
