TM 10-4610-239-24
TM 08580B-24/3
REMOVAL. (Cont)
g. Remove cable sealing grip body (13), washer (15), and nut (10) from booster pump cable assembly (4)
and remove cable from ROWPU.
INSTALLATION.
a. Slide nut (10), washer (1), and cable sealing grip body (3) on booster pump cable assembly (4).
b. Pull booster pump cable assembly (4) through wall of electrical junction box (14) and position cable
sealing grip body (13).
c. Install new O-ring (12) and locknut (11) on cable sealing grip body (13).
d. Install nut (10) on sealing grip body (13).
e. Working inside electrical junction box, position three terminal lugs (9) as tagged, lug washers (8), and
screws (7) on bottom terminals of motor controller K6 (6).
f. Use wire ties to secure three wires to wire bundle on bottom left wall of electrical junction box.
g. Position booster pump cable assembly (4) on ROWPU deck as noted during removal and install two
clamps (3), flat washers (2), and screws (1).
3-159
