TM 10-4610-239-24
TM 08580B-24/3
INSTALLATION OF ROWPU ON FLATBED CARGO TRAILER. (Cont)
g.
Install pump covers. Refer to TM 10-4610-239-10.
h.
Install portable items on ROWPU. Refer to TM 10-4610-239-10.
i.
Install ROWPU cover. Refer to TM 10-4610-239-10.
TEST.
FLATBED CARGO TRAILER
a.
Hook up towing vehicle. Refer to TM 10-4610-239-10.
b.
Start engine of towing vehicle and wait for towing vehicle air compressor to fully charge flatbed
cargo trailer brake system. Refer to Operator's Manual for towing vehicle.
c.
Uncage compression springs on all four air chambers. Refer to paragraph 2-47.
d.
Check airbrake system for leaking compressed air.
e.
Check lighting system for proper operation of all lights.
f.
Lubricate chassis in accordance with LO 10-4610-239-12/LI 08580B-12.
g.
Tow flatbed cargo trailer at different speeds to ensure proper operation.
ROWPU
NOTE
This test checks overall operating condition of ROWPU after repair. The test
consists of operating the ROWPU on synthetic sea water for 6 hours, followed
by a backwash cycle, then a fresh water flush of the ROWPU.
a.
Lubricate chemical feed metering pump. Refer to LO 10-4610-239-12/LI 08580B-12.
b.
Lubricate R.O. pump. Refer to LO 10-4610-239-12/LI 08580B-12.
NOTE
During preparation of ROWPU for test, position tanks and pumps and connect
hoses and pump power cables according to steps e thru q. Perform other steps in
ROWPU preparation according to TM 10-4610-239-10.
c.
Prepare ROWPU for use. Refer to TM 10-4610-239-10.
4-13
