TM 10-4610-239-24
TM 08580B-24/3
DISASSEMBLY. (Cont)
CAUTION
Mark the top of each connecting rod cap for assembly. Incorrect installation of
connecting rod cap may damage equipment.
NOTE
There are five connecting rods. All are disassembled the same. One is shown.
e.
Remove two cap screws (11), lockwashers (12), connecting rod cap (13), and shell bearing half
(14). Discard shell bearing half (14).
f.
Push connecting rod (15) out of cylinder away from crankshaft (16).
g.
Remove five cap screws (17), extension guard (18), bearing housing (19), and shim gasket (20).
Discard shim gasket (20).
h.
Remove oil seal (21) from bearing housing (19). Discard oil seal (21).
i.
Using bearing puller, remove bearing (22) from bearing housing (19).
k.
Remove five cap screws (23), bearing housing (24), and shim gasket (25). Discard shim gasket (25).
L.
Remove oil seal (26) from bearing housing (24). Discard oil seal (26).
4-19
