TM 10-4610-239-24
TM 08580B-24/3
ASSEMBLY. (Cont)
NOTE
Torque cap screws to 195 lb-ft (264N.m) in crossing pattern as follows:
1
3
4
5
2
Bearing adjustment is accomplished by using varying thicknessess of
shim gaskets. Adjustment is correct when the cap screws have been
tightened and only a slight drag is noticeable when crankshaft is
rotated. Two or more shim gaskets may be used on each bearing
housing to obtain the correct adjustment.
o.
Install new shim gasket (25), bearing housing (24), and five cap screws (23).
p.
Install new shim gasket (20), bearing housing (19), extension guard (18), and five cap screws (17).
CAUTION
Assemble connecting rod caps and shell bearings as marked during disassembly.
Incorrect assembly of connecting rod caps and shell bearings may damage
equipment.
NOTE
There are five connecting rod caps. All are assembled the same. One is shown.
q.
Position new shell bearing half (14) and connecting rod cap (13) on connecting rod (15) with top
as marked in disassembly.
r.
Install two cap screws (11) and lockwashers (12) to secure connecting rod cap (13).
s.
Torque two cap screws (11) 18 to 24 lb-ft (24 to 33N.m).
t.
Position new gasket (10) and crankcase cover (9) on R.O. pum power frame (28) and install 16 cap screws (8).
p
4-24
