TM 10-4610-240-10
TM 08580C-10/1
T.O. 40W4-13-21
The solid state timer is approximately 8 inches high, 10 inches wide and 6 inches deep. Protruding from the bottom of
the timer is the pilot controller. Inside the timer is a white OVER-CURRENT PROTECTION PUSH TO RESET switch
and six green LED (light emitting diode) indicator lights. The solid state timer operates automatically and does not
contain any operator controls. The six green indicator lights illuminate in response to the following backwash functions:
Indicator Light:
REGEN - Flashing light indicates backwash timer is in operation.
0 - IN SERVICE (Backwash cycle not in operation)
1 - SLOW BACKWASH
2 - FAST BACKWASH
3 - SLOW BACKWASII
4- RINSE
CAUTION
To prevent damage to the equipment, the OVER-CURRENT PROTECTION PUSHI TO RESET switch
must not be depressed during operation. RESET switch should only be depressed when required by
troubleshooting or maintenance procedures.
FIGURE 2-70. SOLID STATE TIMER
2-70
