TM 10-4610-240-10
TM 08580C-10/1
T.O. 40W4-13-21
WARNING
LEVELING JACK IS SPRING LOADED. USE CARE
WHEN PULLING OUT LEVELING JACK TO
PREVENT PERSONAL INJURY.
11. POSITION CRANK HANDLE (24) ON REAR JACK
(26)
AND
TURN
HANDLE
COUNTERCLOCKWISE TO RAISE JACK PAD
(27).
12. TO ROTATE REAR LEVELING JACK TO
HORIZONTAL POSITION, REMOVE CRANK
HANDLE. GRASP JACK AND PULL STRAIGHT
OUT AGAINST SPRING TENSION. ROTATE
JACK UP TO HORIZONTAL POSITION. ALLOW
JACK TO SPRING BACK TO LOCKED
POSITION.
13. POSITION CRANK HANDLE (24) ON REAR JACK
(26) AND TURN HANDLE CLOCKWISE TO
EXTEND JACK PAD (27). LINE UP HOLE IN
JACK PAD WITH ROUND BAR (28) ON
SECUREMENT PLATE (29).
EXTEND JACK
14. REPLACE CRANK HANDLE (24) ON REAR OF
UNTIL JACK PAD RESTS FIRMLY AGAINST
JACK SUPPORT BRACKET (25); INSTALL
SECUREMENT PLATE.
SAFETY PIN (23).
FIGURE 2-76. PREPARATION FOR MOVEMENT (SHEET 6 OF 7) (ARMY)
2-89
