TM 10-4610-241-10
TO 4OW4-13-41
2-17. PREPARATION FOR MOVEMENT - cont.
(8)
Screw plug into discharge coupling.
(9)
Screw plug into suction coupling.
(10)
Position backwash strainer on top of backwash pump and secure with tie strap.
O.
Remove Raw Water Pump No. 2 Quick Disconnect Fittings. Refer to figure 2-27.
NOTE
Raw water pump No. 2 has two female quick disconnect fittings.
(1)
(2)
Open drain and vent valves on raw water pump No. 2.
Remove 1 1/2-inch female quick disconnect fitting from discharge coupling of raw water pump
No. 2.
(3)
Remove 1 1/2-inch female quick disconnect fitting from suction coupling of raw water pump No.
2.
(4)
Screw plugs into suction and discharge couplings of raw water pump No. 2.
p.
Remove Raw Water Pump No. 1 Quick Disconnect and Strainer Fittings. Refer to figure 2-26.
NOTE
Raw water pump No. 1 has both a male and female quick disconnect fitting.
(1)
(2)
(3)
(4)
(5)
Open drain and vent valve on raw water pump No. 1.
Remove 1 1/2-inch male quick disconnect fitting from raw water strainer.
Remove 1 1/2-inch male quick disconnect fitting from discharge coupling.
Remove 1 1/2-inch female quick disconnect fitting from suction coupling.
Screw plugs into suction and discharge couplings on raw water pump No. 1.
Remove Control Panel Quick Disconnect Fittings. Refer to figure 2-25.
(1)
Remove 1 1/2-inch male quick disconnect fittings from PRODUCT WATER, BRINE, and RAW
water hose couplings on control panel.
(2)
Install caps on PRODUCT WATER, BRINE, and RAW water hose couplings on control panel.
(3)
Remove 2-inch male quick disconnect fittings from WASTE, VENT VESSELS, and
BACKWASH water hose couplings on control panel.
(4)
Install caps on WASTE, VENT VESSELS, and BACKWASH water hose couplings on control
panel.
2-139
