TM 10-4610-241-10
TO 4OW4-13-41
2-17. PREPARATION FOR MOVEMENT - cont.
CAUTION
Cargo straps must crisscross over top of stowed accessories to prevent movement of
components during transport. To prevent damage to the equipment, use care not to
crush components when tightening cargo straps.
(15)
Position cargo straps over accessories and connect ratchet end of strap to front of ROWPU frame.
Operate ratchets until straps are tight.
NOTE
On Models H-9518-2, and H-9518-3 the distribution pump, chemical cans, frame, and
calcium hypochloride are shipped separately.
Rear of Trailer (H-9518-1 only)
(16)
(H-9518-1) Stow chemical feed cans and rack (1) on trailer. Secure chemical cans to rack, and rack
to trailer frame with hold down straps.
(17)
(H-9518-1) Stow distribution pump (2) on trailer frame and secure with hold down straps.
(18)
(H-9518-1) Place ladder (3) on distribution pump frame and secure with hold down straps.
(19)
(H-9518-1) Stow calcium hypochlorite crate on trailer frame and secure with hold down
straps.
s.
Install Cross Braces. Refer to figure 2-21.
(1)
Position top cross brace on ROWPU frame. While depressing detent pin with thumb, push quick
release pins in both ends of top cross brace.
(2)
Position bottom cross brace on ROWPU frame. While depressing detent pin with thumb, push quick
release pins in both ends of bottom cross brace.
t.
Lower canvas cover. Refer to figure 2-20.
(1)
Unfasten tie straps and lower all four sides of canvas cover.
(2)
Fasten corner tie straps to secure front, rear, left and right canvas panels.
(3)
Fasten tie straps along bottom of canvas cover to ROWPU frame.
CAUTION
In order to release trailer air brake system, towing vehicle must have 90-130 psi of air
pressure.
u.
(Models WPES-10 and H-9518-1) Refer to figure 2-77 and prepare trailer for movement.
Change 2
2-142.1/(2-142.2 blank)
