TM 10-4610-241-10
TO 4OW4-13-41
2-17. PREPARATION FOR MOVEMENT - cont.
CAUTION
Movement of trailer without proper positioning of
jacks will result in damage or destruction of jacks.
8.
WITH CRANK HANDLE (7) IN POSITION ON FRONT JACK (9),
TURN CRANK HANDLE COUNTERCLOCKWISE AND FULLY
RAISE JACK PAD (20)
10.
POSITION CRANK HANDLE (7) ON FRONT JACK (9) AND TURN
HANDLE CLOCKWISE TO EXTEND JACK PAD (20). LINE UP
HOLES IN JACK PAD WITH ROUND BAR (2) ON SECUREMENT
PLATE (22). EXTEND JACK UNTIL JACK PAD RESTS FIRMLY
AGAINST SECUREMENT PLATE.
WARNING
Leveling jack is spring loaded. Use care when
pulling out leveling jack to prevent personal injury.
9.
TO ROTATE FRONT LEVELING JACK TO HORIZONTAL
POSITION, REMOVE CRANK HANDLE, GRASP JACK AND PULL
STRAIGHT OUT AGAINST SPRING TENSION. ROTATE JACK UP
TO HORIZONTAL POSITION. ALLOW JACK TO SPRING BACK
TO COCKED POSITION.
11.
REPLACE CRANK HANDLE (7) ON REAR OF JACK SUPPORT
BRACKET (8); INSTALL SAFETY PIN (6)
Figure 2-77. Trailer Preparation for Movement (Sheet 4 of 6)
(Models WPES-10 and H-9518-1)
2-146 Change 2
