TM 10-4610-241-10
TO 4OW4-13-41
3-12. TIRE AND WHEEL ASSEMBLY SERVICING (MODELS WPES-10
AND H-9518-1) - cont.
Remove spare tire from trailer (Refer to figure 3-15)
(8)
Using lugnut wrench and handle, remove two nuts (1) from studs (2).
(9)
Remove safety pin (3) and separate crank handle (4) from jack assembly (5).
(10)
Install crank handle (4) on end of ratchet (6).
WARNING
Tire and wheel weigh about 122 pounds (55.39 kg). Use care when releasing pawl
to prevent injury to personnel or damage to the equipment.
Do not allow personnel under trailer when lowering tire and wheel.
(11)
While pushing down on pawl (7), turn crank handle (5) to the left to lower spare tire and wheel
(8) to the ground.
(12)
Remove tire carrier support (9) and attached cable (10) from center of spare tire and wheel (8).
3-46