TM 10-4610-241-10
TO 40W4-13-41
3-12.
T I R E A N D W H E E L A S S E M B L Y S E R V I C I N G ( M O D E L S W P E S - 1 0
AND H-9518-1) - cont.
Install spare tire on trailer (Refer to figure 3-15)
(7)
Place tire carrier support (9) and attached cable (10) inside spare tire and wheel (8) and position
support so that studs (11) fit in lug mounting holes.
WARNING
•
Tire and wheel weigh about 122 pounds (55.39 kg). Use care when releasing pawl
to prevent injury to personnel or damage to the equipment.
•
Do not allow personnel under trailer when raising tire and wheel.
(8)
Turn crank handle (5) to the right and raise tire and wheel (8) up to studs (2). Aline mounting
holes in wheel with stud, then raise wheel until seated against bottom of trailer.
(9)
Using lugnut wrench, install two nuts (1) on studs (2).
(10)
Remove crank handle (4) from end of ratchet (6) and stow on jack assembly (5).
(11)
Secure crank handle (4) in place with safety pin (3).
Change 2
3-49/(3-50 Blank)
