TM 10-4610-241-10
TO 40W4-13-41
a. Treating Mildewed Areas. Canvas that has mildewed can be cleaned by scrubbing with a dry brush. If it is
necessary to use water to remove dirt, it should not be used until mildew has been removed. After removing mildew,
examine fabric. Look for evidence of deterioration. If canvas has deteriorated it should be replaced.
NOTE
Use only those authorized cleaning solvents or agents listed in Appendix D.
b. Cleaning Rust or Grease. When cleaning grease buildup or rusty places, use a cleaning solvent. Then apply a
thin coat of light oil to affected area.
2-7. LEAKAGE DEFINITIONS FOR OPERATOR PMCS. It is necessary for you to know how fluid leakage affects the
status of the ROWPU.
Following are types/classes of leakage an operator needs to know to be able to determine the status of
the ROWPU. Learn these leakage definitions and remember - when in doubt, notify your supervisor.
NOTE
Use only those authorized cleaning solvents or agents listed in Appendix D.
l
Equipment operation is allowable with minor leakages (Class I or II). Of course, consideration must be
given to fluid capacity in the item/system being checked/inspected. When in doubt, notify your
supervisor.
l
When operating with Class I or II leaks, continue to check fluid levels an required in your PMCS.
l
Class III leaks should be reported immediately to your supervisor.
a.
CLASS I - Seepage of fluid (as indicated by wetness or discoloration) not great enough to form drops.
b.
CLASS II - Leakage of fluid great enough to form drops but not enough to cause drops to drip from item being
checked/inspected.
c.
CLASS III - Leakage of fluid great enough to form drops that fall from item being checked/inspected.
Table 2-2. Operator Preventive Maintenance Checks and Services
Item
N o .
1
Interval
Before
2
Before
Location
Item To Check/
Service
Flatbed Cargo Trailer
Generator Set
Procedure
a. Inspect taillights for cracked lenses
and verify all trailer lights for proper
operation.
b. Check tires for proper inflation
(Model WPES-10: 75 psi; Model H-
9518-1:50 psi).
Check Generator (Refer to TM 5-
6115-465-12)
Not Fully Mission
Capable If:
Lights inoperable
Tire is flat
In Accordance With TM 5-
6115-465-12
Change 2 2-27
