TM 10-4610-241-24
TO 40W4-13-42
3-51.
WIRING HARNES, W2 REPAIR.
This task consists of:
a.
Removal
b.
Cleaning
c.
Inspection
d.
Test
e.
Repair
f.
Installation
INITIAL SET-UP:
Tools Required
General Mechanics Tool Kit (Appendix B, Section III, Item 4)
Multimeter (Appendix B, Section III, Item 3)
Refer to TM 43-0158/TO 1-1A-15 (Air Force) for Tools required to repair Wiring Harness.
Material/Parts Required
Lockwashers (TM 10-4610-241-24P)
Tiedown Straps (TM 10-4610-241-24P)
Refer to TM 43-0158/TO 1-1A-15 (Air Force) for Materials/Parts required to repair Wiring
Harness.
Equipment Condition
Reference
Control box removed from ROWPU (Paragraph 3-49).
a.
Removal.
(1)
Remove four nuts (1), lockwashers (2), flat
washers (3), and screws (4).
(2)
Remove receptacle connector (5) and gasket (6)
from control box (21).
(3)
Disconnect wires (8) from switches and terminal
boards etc (see table on opposite page) by
removing or loosening screw (7).
(4)
Remove ground lug (12) and ground wires (13)
of wiring harness not removed by removing nut
(9),
lockwasher
(10),
flatwashers
(11),
lockwasher (15) and screw (14).
(5)
Remove clamps (19) as necessary by removing
nuts (16), lockwashers (17) and screws (18).
(6)
Cut tiedown straps as necessary and carefully
remove wiring harness (20) from control box
(21).
3-295
