ARMY TM 10-4610-309-14
MARINE CORPS TM 10802A-14/1
0050 00
TACTICAL WATER PURIFICATION SYSTEM (TWPS)
UNIT MAINTENANCE PROCEDURES
DIESEL ENGINE AND FUEL TANK ASSEMBLY
Engine Oil and Oil Filter Replacement:
Parts (TM 10-4610-309-24P)l:
Oil filter
Oil filter o-ring
Engine lubricating oil (BII) (WP 0079, Table 1, item 19)
Materials:
Approve container for collecting oil drained from the engine
Clean rags (WP 0079, Table 1, item 23)
Replace the engine oil and oil filter as follows (see Figure 16):
NOTE
Make sure the engine is sitting level so all of the oil will drain out.
1.
Position a container below the oil drain plug.
2.
Remove the oil filler cap/dipstick.
3.
Remove the drain plug and drain the oil. Reinstall the drain plug after all the oil has drained out.
4.
Remove the oil filter lock bolt.
5.
Remove and discard the oil filter and the filter O-ring.
6.
Install the replacement oil filter and O-ring and secure with the lock bolt.
O-RING
OIL FILTER
OIL FILLER CAP/DIPSTICK
LOCK BOLT
OIL DRAIN PLUG
Figure 16. Engine Oil and Filter Replacement.
7. Fill the crankcase with oil until the level reaches the full mark on the dipstick (approximately 3/4 of
a quart).
8. Screw the oil filler cap/dipstick back into the filler port.
0050 00-20
