ARMY TM 10-4610-309-14
MARINE CORPS TM 10802A-14/1
0059 00
TACTICAL WATER PURIFICATION SYSTEM (TWPS)
UNIT MAINTENANCE PROCEDURES
OPERATING CONTROL SYSTEM TOP PANEL
COMPUTER CABLE CONNECTORS
PROCESSOR MODULE
GASKET
DUST CAP
OCP BOX
COMPUTER
CABLES
Figure 15. Computer Cable Assembly Replacement.
2. Install new computer cable assembly as follows:
a. Position the new gasket through the harness end of the new cable assembly up to the
connector end of the cable assembly.
b. Insert the harness end of the cable assembly through the connector hole of the OCP box
and feed up to the processor module.
c. Align the gasket and the connector with screw holes on the OCP box.
d. Position the end of dust cover chain on one of screw holes with the connector and
gasket.
e. Secure the connector, gasket and dust cover chain to the OCP box using the four
screws, washers and lock nuts.
f. Connect the harness end of the cable to the connector of the processor module.
g. Close processor module compartment door.
h. Replace wire duct covers.
i. Close sub panel door
j. Close OCP top panel.
END OF WORK PACKAGE
0059 00-20
