TM 10-4610-310-14
0003 00
The following set of descriptions will allow the operator to distinguish the cables and aid in connection of these
cables.
Power cable
It has four loose wires on one end, which enables it to be connected to the 3 KW TQG. It has white shrink-wrap
on it.
Ground cable
Both ends of this cable are unfinished. The cable is used to connect the control module to the grounding rod.
Pump cables
There are four of these cables. They have an elbow connection on one end and a straight connection on the other
end. These cables are different in length but are interchangeable if necessary. They connect the raw water pump;
booster pump, backwash pump and distribution pump to the control module. The elbow connection connects to
the pump and the straight connection connects to the control module.
Module cables
The UF, HP and chemical modules have cables that are hard wired on to the respective module. These modules
are to be connected to the control module.
Flow process diagrams can be seen from figure 11 through 15.
Figure 11. Water Source to Ultrafiltration Module Piping Diagram.
