TM 10-4610-310-14
0003 00
Emergency shutdown
The engine is equipped with an emergency air shutoff device. The electrical signal from control panel activates
the 3 way electrical solenoid, which allows air pressure to reach the air cylinder, which then opens the air intake.
The air intake is closed off in the absence of the signal from control panel resulting engine shutdown.
HOSE ADAPTERS
The hose adapters are used in cleaning and flushing procedures. They are packed inside the BII box.
Cleaning Adapter
This adapter is used in cleaning the RO module. It allows the connection of a regular camlock fitting to the high-
pressure fitting on the RO module inlet.
Figure 8. Cleaning Adapter
Flushing Adapter
This adapter is used in product flush procedure where the LWP is flushed with clean product water to eliminate
the raw water within the system to prevent corrosion and growth of bacteria. The adapter allows the connection of
the 1-1/2 inch hose to the discharge of the distribution pump, which has a 3/4-inch connection.
Figure 9. Flushing Adapter
Cleaning Outlet
This is used when cleaning the UF module. The outlet allows some permeate to be tapped and therefore relieves
the pressure built up on the permeate side.
Figure 10. Cleaning Outlet
