TM 10-4610-310-14
0128 00
INSTALLATION
1. Install the terminal block inside junction box assembly on mounting rail. Install the bottom end first and then
snap the top portion in. Secure with end stops on mounting rail.
2. Position the junction box assembly on the module. Secure with four machine screws, flat washers, and new
lock nuts.
3. Begin routing wiring through hubs.
4. Connect wiring to terminals on terminal block. Reuse the wire number tags from the old wires. Refer to Figure
4.
5. Install cover on junction box assembly. Secure with four screws.
6. Re-establish electrical power and fluid service to high-pressure pump module.
Figure 4. HP Module Wiring Diagram.
END OF WORK PACKAGE
0128 00-3 / 4 blank
