TM 3-4230-204-12&P
2
3
CAUTION
Be sure to remove nitrogen cylinder from bracket when
installing the bracket.
NOTE
Before installing the bracket, check the authorized
equipment technical manual, local policy directives and
SOPs to see if a standard location has been selected. If
not, select a location the same as used on other
equipment of a similar type. The location selected will
provide space enough to hold the M11 DECON in the
bracket in an upright position. It must not block or
hamper any other installed equipment or controls. The
bracket will not be mounted in such a way to cause
injuries to personnel while performing routine duties.
The M11 DECON mounting is determined by the type of
equipment involved. Normally it will be internally
mounted. It must be mounted in a vertical position.
The bracket shall be installed on the authorized
equipment using the three mounting holes in the
bracket as guides as soon as possible on receipt of
equipment. This task covers a typical installation. You
may come across an installation that is not typical. You
will have to adapt these procedures to fit that
Unlatch bracket strap latch (1) and remove the M11 DECON (2).
installation.
The bracket will be installed on the authorized
equipment and the M11 DECON placed in storage if not
required.
4-9
