TM 3-4230-218-30&P
2-8. GASOLINE ENGINE ASSEMBLY.
This task consists of:
a.
Replace
b.
Repair
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics
Torque Wrench
Crankshaft Retainer (Appendix D)
Socket Set, Metric
Flywheel Puller and Extender Nuts
Clutch Puller
Timing Dial Indicator
Metric Crowfoot
Piston Retainer Tool (Appendix D)
Socket Adapter
Wrist Pin Tool (Appendix D)
Materials Required:
Brush, Varnish (item 1, Appendix C).
Cleaning Solvent (item 5, Appendix C).
Gasket, Carrier (P/N 102-41-729-000).
Grease, Bearing (item 3, Appendix C).
Compound, Locking (item 2, Appendix C).
Cloth, Abrasive (item 7, Appendix C).
Equipment Conditions:
Engine and fan assembly removed and disassembled (page
2-22).
Starter removed (TM 3-4230-218-12&P).
Carburetor removed (page 2-40).
a.
Generator/Ignition System.
(1) Removal.
(a) Remove six bolts (1), six lockwashers (2), and fan cover
(17).
(b) Screw 13mm bolt into center of cover to help remove it.
(c) Remove ring (16), three nuts (15), three washers (14),
carrier (13), and gasket (12). Install crankshaft retainer
(Figure D-1) on fan housing (9) and secure with extender
nuts (15).
(d) Remove nut (11) and lockwasher (10).
NOTE
Fan housing has two keyways.
Mark the keyway in which the key is installed.
2-28