TM 3-4230-237-10
0008 00
MIXING CHEMICALS OTHER THAN STB IN TANK - Continued
Sodium Hypochlorite - Continued
10
DECONTAMINATINGAPPARATUSM12A1
VAVALE NO.22
LVVE NO.
DECONTAMINATING APPARATUSM12A1
SERNO.
LOWER REEL
SERNO.
NSN
NSN
PBAUPGRADEDATE
PBAUPGRADEDATE
U.S.
U.S.
HEATER OFF
REATEPTACLE OFF
HECER
VVALVE NOO. 1
ALVE N .1
RECEPTACLE
11
AND SWITCH
AND
MANIFOLD
ON
SWITCH ON
CAUTION
TO AVOID FREEZE DAMAGE KEEPPUMP
DRAIN VALVE OPEN WHEN EQUIPMENT IS
NOT IN OPERATION.
DRAIN
DRA-
OP- N
CLOSE-
CLOSD
OPE
VALVE NO. 1
11
12
7
1. Fill the tank unit with 350 gallons of water. See Page 0007 00-12 for hose, fuel, and electrical connections for heating
water in tank. Heat the water to an indicated temperature of 150-175 F. After heating the water, place THERMOSTAT to
OFF. Continue circulating water for 2 minutes through the heater, then turn HEATER ON/OFF switch to OFF.
2. Place the HEATER RECEPTACLE AND SWITCH (10) on pump unit to OFF and then disconnect the electrical power
cable (11) and cap the socket.
WARNING
When disconnecting the hoses with the water temperature at or above 100 F (38 C), exercise extreme care
to prevent scalding.
3. Either shut down the pump unit or close VALVE NO. 1. Disconnect the water hose (12) from the tank unit agitator
pipe (7).
0008 00-13
