TM 3-4230-237-10
0008 00
MIXING WATER AND LIQUID CHEMICALS USING THE PRIME DETERGENT TANK - Continued
Liquid Detergent
15
1. Heat the water in the tank to approximately 90F (32.2C) (Page 0007 00-12).
CAUTION
Hot water is present in the heater and will drain when blender hose is disconnected.
2. Disconnect the water heater. Cap both discharge pipes (15) on the connector panel immediately. Do not allow the pump
to drain.
VALVE NO. 3
VALVE NO. 2
VALVE NO.22
VALVE NO.
VALVE NO.3
UPPEVEEEO.
VALR RNL
3
LOWER REEL
16
FUEL
FUEL INDICATOR
V
VVALVE NOO. 1
ALVE N .1
HOUR METER
8
MANIFOLD
HOURMET-
SLAVEE
SLAV
RECEPTACLE
OPPN
OE-
P
9
VALLVEMEO.44
VA
VRI NO.
EN
CLOSED
P
VALVE NO. 4
VALVE NO. 1
3. Remove prime detergent tank lid (16) and fill the prime-detergent tank with 1 pint of liquid detergent and water.
4. Open VALVE NO. 1. Unreel the discharge hoses (8) and open VALVES NO. 2 and 3 if both hose reels are to be used.
5. Start the pump unit. Open VALVE NO. 4 slightly to add the detergent mixture to the water.
6. Open valve (9) on the gun assembly and begin spraying liquid detergent mixture.
7. After spraying mission is complete, clean and store the apparatus according to applicable procedure listed in Work
0008 00-21
