TM 5-3800-205-10-2
RAIL TRANSPORT - CONTINUED
0020 00
CONFIGURE MACHINE FOR RAIL TRANSPORT - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure any lifting device used is in good condition and of suitable lift capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may result in death or injury to person-
nel.
NOTE
ROPS/FOPS weighs 447 lb (203 kg).
10.
OCONUS ONLY: Remove ROPS/FOPS and set aside for stowage in ISU-60 container:
a.
Attach a suitable overhead lifting device to three lift points on top of ROPS/FOPS. Take up slack in slings.
b.
Remove 16 nuts, 32 washers, and 16 bolts from four corners of ROPS/FOPS.
c.
Lift ROPS/FOPS free of cab corner posts and lower to the ground.
d.
Stow mounting hardware in BII toolbox on rear deck of water distributor.
ROPS/FOPS
390-1021
BOLTS, WASHERS,
CAB CORNER POST
AND NUTS
CAUTION
Always wipe ends clean prior to disconnecting hydraulic lines. Ensure ends are clean prior to reconnecting.
Failure to do so may introduce contamination into hydraulic system.
11.
OCONUS ONLY: Remove two water pump motor hydraulic hoses as follows:
a.
On left side of draft frame, disconnect two water pump motor hydraulic hoses at quick disconnects. Install dust
caps.
0020 00-9
