TM 5-3800-205-10-2
RAIL TRANSPORT - CONTINUED
0020 00
RETURN MACHINE TO OPERATIONAL CONFIGURATION - CONTINUED
c.
Remove dust caps and connect other end of hoses to quick disconnects on top of draft frame.
WATER PUMP MOTOR
HYDRAULIC HOSES
QUICK DISCONNECTS
DUST CAPS
390-1465
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure any lifting device used is in good condition and of suitable lift capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may result in death or injury to person-
nel.
NOTE
ROPS/FOPS weighs 447 lb (203 kg).
6.
OCONUS ONLY: Install ROPS/FOPS on cab corner posts:
a.
Attach a suitable overhead lifting device to three lift points on top of ROPS/FOPS. Take up slack in slings.
NOTE
Tighten all mounting nuts using a crisscross tightening pattern. This will ensure even tightening and correct
installation alignment on all four cab corner posts.
b.
Lift ROPS/FOPS into position at four corner posts. While positioning ROPS/FOPS, loosely install all 16 bolts, 32
washers, and 16 nuts. Final tighten nuts in a crisscross tightening pattern to 317 lb-ft (430 Nm).
0020 00-29
