TM 5-3800-205-10-2
RAIL TRANSPORT - CONTINUED
0020 00
RETURN MACHINE TO OPERATIONAL CONFIGURATION - CONTINUED
NOTE
It is important to stow components in container in accordance with indicated sequence. This will ensure effi-
cient and timely packing of container.
12.
OCONUS ONLY: Stow the following items in ISU-60 container in accordance with illustrations and information in
Tables 4 and 5.
a.
four steering locking collar assemblies, two short (6 5/8 in.) and two long (10 3/4 in.);
b.
exhaust extension;
c.
toolbox;
STEERING CYLINDER LOCKING
COLLAR ASSEMBLIES
EXHAUST
EXTENSION
RAMPS
TRAY
RETAINING
PIN
390-1119
TOOLBOX
Table 4. Stowage Instructions for ISU-60 Container - Single-Door End.
COMPONENT
STOWAGE INSTRUCTIONS
1.
Place steering cylinder locking collar assemblies in two right cutouts in cushion
Steering Cylinder
pad, on left side of shelf.
Locking Collar Assem-
2.
Place exhaust extension in left cutout in cushion pad, on left side of shelf.
blies and Exhaust
3.
Secure with three straps.
Extension
Toolbox
1.
Place toolbox on front edge of tray.
2.
Secure with three straps.
3.
Slide tray all the way in.
4.
Secure tray with two pins through tray and container floor.
Ramps
1.
Position each ramp against wall of container.
2.
Secure each ramp with strap.
CAUTION
Check to ensure all components are securely fastened prior to closing and
securing door. Failure to do so may result in damage to equipment.
0020 00-33
