TM 5-3800-205-23-3
REAR TIRE AND RIM REPLACEMENT - CONTINUED
0017 00
REMOVAL - CONTINUED
2.
Position hydraulic jack under water tank frame at jacking point.
3.
Raise rear of tank and position two support stands at support points.
JACKING
SUPPORT
SUPPORT
POINT
POINT
POINT
NOTE
1,2
3
Sixteen nuts and washers are used to
4
secure tire to water tank. Remove only 14
at this time.
4.
Remove 14 nuts (1) and washers (2) from rim (3).
Leave two nuts and washers on rim to hold tire (4) in
place.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
0017 00-2
