TM 5-3800-205-23-3
REAR HANDRAILS AND STEP ASSEMBLY MAINTENANCE - CONTINUED
0018 00
ACCESS PANEL LATCH ASSEMBLY INSTALLATION - CONTINUED
2.
Install latch (10) to bracket (11) with two screws (9) and new locknuts (8). Repeat for other side.
3.
Unsecure prop rod (7) and close access panel (5).
4.
Secure access panel (5) in closed position with latch assembly (6) on each side of access panel.
STEP ASSEMBLY REMOVAL
1.
To improve access to remove step assembly (17), remove rear handrails (Refer to Rear Handrails Replacement).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Step assembly weighs 153 lb (69 kg).
1.
Remove four bolts (15) and washers (16) from step assembly (17).
2.
With assistance, remove step assembly (17) from water distributor frame.
17
15,16
0018 00-3
