TM 5-4610-218-12
filtered and waste water hose outlets (fig. 1-3) and
(3) Disconnect extension cable from pump
raw water inlet (fig. 1-2).
cable (fig. 4-5) and store it in the van body.
(2) Install the cap on the generator and raw
(4) Roll the pump cable on the cable bracket
water pump cable inlet (fig. 1-2).
(5) Place the distribution pump on the mount-
4-9. Loading and Transporting Water Puri-
ing pads in the rear section of the van body floor ad-
fication Equipment.
jacent to the raw water pump. Secure the pump
with four 3/8-16 x 1-1/4 inch capscrews and lock-
a. Loading Accessories and Equipment into
washers.
Van Body and Trailer.
(1) Tape the male end of hoses or wrap them
h. Water Lines Between Storage Tanks.
with a protective material to prevent damage dur-
(1) Disconnect the male end of hose from the
ing transporting.
second storage tank female inlet.
(2) Tie the hoses in bundles and load them in
(2) Install the cap in the female inlet.
the van body.
(3) Remove the hose from adapter and lay the
(3) Store part of the chemicals in the trailer
hose aside out of the way.
and part in the van body. Fill the trailer first.
(4) Remove adapter from the valve and dis-
(4) Place the water testing equipment (com-
connect valve from the adapter.
parator, residual chlorine disk, and solution bottles)
(5) Remove the adapter from the first storage
in the stowage box.
tank female outlet.
(5) Place the kitchen scoop and chemical mea-
(6) Install the cap in the female outlet.
sures in the stowage box.
(7) Store adapters and valves in the accessory
(6) Disconnect the extension lights and place
stowage box.
them in the stowage box.
i. Filter Water Hose.
(7) See that all tools and accessories have
(1) Remove hose (fig. 4-5) from the first stor-
been placed in the stowage box. Close the box and
age tank.
secure it to its frame.
(2) Disconnect the hose from van body filtered
(8) Stack the rubber pails, one inside the oth-
water hose outlet.
er, and place them upside down on the floor of the
van body.
(3) Lay the hose aside out of the way.
(9) Remove the four leveling jacks from under
j. Water Storage Tanks.
the can body and store them in the jack stowage
NOTE
rack.
Make sure all chain caps are on the
(10) Secure the rear entrance ladder assembly
outlets of the storage tank.
in the ladder holder on the inner side of the rear van
door.
(1) Fold the tanks, top covers, and ground
cloths into bundles and tie them with part of the
(11) Secure the side entrance ladder assembly
guy ropes. Avoid sharp creases.
in the ladder holder on the inner side of the right
van door.
(2) Place the bundles containing the tanks,
tank covers, and ground cloths in the trailer.
(12) Lash down or block the equipment and
supplies in the van and trailer to prevent move-
ment.
CAUTION
(13) Install wood braces between the effluent
launder and mounting brackets with steel bands.
Do not walk on the collapsed tanks or
stack heavy objects on them.
(14) Close and tape all van body windows to
prevent damages in transporting.
k. Miscellaneous.
(15) Close the side panels and doors of the van
(1) Install hose adapter caps on the van body
body. Lash down the tarpaulin on the cargo trailer.
4-14
