TM 5-4610-218-12
Figure 4-7. Electrical Cables, Installed.
(3) Filtered water distribution pump. Con-
(a) Connect the cable leads on one end of
the power cable to the electrical terminals of the
nect the distribution pump cable male plug con-
generator. Seee applicable generator technical
nector to the female plug connector end of a 50-foot
manual.
(15 m) extension power cable assembly. Remove the
cap from the cable inlet (fig. 1-2) on the right side of
(b) Insert the generator power cable
the van body. Insert the 6-foot (1.8 m) extension
through the van body outlet.
electric cable assembly (fig. 4-7) through the van
(c) Open the electrical control cabinet door
body cable inlet, and connect the distribution pump
male plug connector to the female connector located
opening in the bottom of the cabinet.
below the chemical solution feeder (fig. 1-5). Con-
nect the opposite end of the 6-foot (1.8 m) extension
(d) Loosen the four terminal nuts enough
cable to the male plug connector of the 50-foot (15
to allow an opening wide enough to insert wires in
the slots of the terminal studs.
m) cable.
(4) Solution feeder. Connect the female plug
(e) Connect generator power cable wire L1
to phase 1 terminal, L2 to phase 2, L3 to phase 3,
connector on the solution feeder power cable to the
receptacle connector on the solution feeder (fig. 1-
and 0 to the neutral terminal. Tighten the four nuts
5).
down to the studs securely.
(f) When making connections, be sure the
(6) Generator set.
numbers on the generator and control cabinet ter-
minals correspond and are connected accordingly.
CAUTION
(g) Close the control cabinet door.
Before making line connections, be
4-6. Servicing New Equipment.
sure the generator is not running and
that all switches are in the OFF posi-
a. Water Purification Unit.
tion.
4-11
