TM 5-4610218-12
Section II. MOVEMENT TO A NEW WORKSITE
cable and male plug connector (fig. 4-7) from the fe-
4-8. Dismantling For Movement.
male plug connector.
a. Genral. The truck and trailer, on which the
(2) Withdraw the extension cable from the
equipment is mounted, are all that is required for
van body cable inlet (fig. 1-2) and disconnect it from
moving the water purification equipment to a new
the raw water pump cable.
location. A minimum of disassembly is required and
care must be exercised to prevent damage.
(3) Roll the cable on the pump frame bracket
b. Generator Electrical Cables and Ground
Rods.
(4) Place the raw water pump on the mount-
ing pads in the rear section of the van body floor as
(1) Open the electrical control cabinet door
shown in fig. 1-3. Secure the pump with four 3/8-16
x 1-1/4 inch capscrews with lockwashers.
connect the four wires (fig. 4-35).
(2) Withdraw the power cable from the elec-
CAUTION
trical control cabinet and van body. Disconnect
power cable from generator and stow securely in the
Identify the pump so that the raw
trailer.
water will not be used for distribution
(3) Install the tarpaulin on the trailer, leav-
without first being cleaned.
ing the rear flap up until all supporting supplies
and equipment have been loaded.
f. Water Distribution Hose and Fittings
(4) Disconnect ground cable assembly (fig. 4-
(1) Remove nozzles (fig. 4-5) from adapers.
5) from the trailer, Be sure to retrieve ground rod
(2) Remove adapters from the two distribu-
and store in the trailer with the ground cable.
tion pump discharge hoses.
(5) Disconnect ground cable assembly (fig. 4-
(3) Disconnect distribution pump discharge
5) from the van body and store it in the van body.
hoses from the siamese connection, and store hoses
c. Waste Water Lines.
in the van body.
(1) Disconnect the hose from, the van body fil-
(4) Remove siamese connection from elbow.
ter waste water outlet.
(5) Store siamese connections adapters and
(2) Disconnect the hose from the van body er-
nozzles in the accessory stowage box (fig. 1-3).
dlator waste water line outlet.
(6) Disconnect hose (fig. 4-5) from the suction
(3) Coil the hoses up and lay aside out of the
side of the pump.
way.
(7) Disconnect the other end of the hose from
d. Raw Water Supply Lines and Float.
the adapter.
(1) Lift the raw water suction hose from
(8) Remove the adapter from the valve.
water supply source, and remove strainer and float.
(9) Remove the valve from the adapter and re-
(2) Store strainer in accessory stowage box,
move adapter from the male outlet second storage
and the float in the trailer.
tank.
(3) Disconnect the raw water suction hose
(10) Store fittings in the stowage box, and lay
from the adapter on the suction side of the pump.
the hoses aside out of the way.
(4) Disconnect the pump discharge hose from
g. Distribution Pump.
the adapter.
(1) If the electric driven water distribution
(5) Disconnect the other end of hose from the
pump was installed, disconnect the extension cable
van body raw water hose inlet.
connector.
(6) Lay the hoses aside out of the way.
(2) Withdraw extension cable from the van
e. Raw Water Pump.
body cable outlet.
(1) Disconnect raw water pump extension
4-13
