TM 5-4610-223-12 Table 3-1.Operator/Crew Preventive Maintenance Checks and Services - Cont NOTE:  Within designated interval, these checks are to be performed in the order listed. B - Before A - After M - Monthly D - During W - Weekly C - Combat Operability Check Interval Item to be Procedures Equipment will Item Inspected Check for and have repaired be reported Not No. B D A W M C or adjusted as necessary. Ready (Red) if: 24 Terminal Inspect the terminal panel for Board broken terminals, damaged threads on terminal studs and nuts, bus bars and corroded and defective terminal screws. 25 Power Inspect power cables for broken Power cable Cables plugs, damaged insulation or defects cannot broken wires. be repaired. 26 Agitator Inspect the motor for signs of Motor is found Drive Motor overheating, worn bearings and defective damaged wires and insulation. 27 Frame Inspect the frame for broken Broken welds Supports welds, bent members, and chipped or bent meml)er and or damaged paint are found Housing 28 Motor Drive Inspect for cracks, chips, excessively   Pulleys found Pulleys worn groove and looseness on shaft, defective or cannot be tightened on shaft. 29 Magnetic Inspect insulation for cracks and Defective Motor other damage.  Inspect contacts magnetic motor Starters and springs for wear on contact starters are points for weak springs. found. Change 5  3-10