TM 5-4610-223-12
Legend for figure 4-95:
1.
Sprocket
9.
Hub plate
2.
Key, machine, sq. 1/4 x 1/4
10.
Pressure ring
x 7/8 in.
11.
Spring
3.
Housing
12.
Adjusting nut
4.
Lockring
13.
Lockring
5.
Drive hub
14.
Collar
6.
Key, machine, sq. 3/16 x
15.
Setscrew, cup point, 5/16-18
3/16 x 1-1/2 in.
x 3/8 in.
7.
Backplate
16.
Setscrew, cup point, 5/16-18
8.
Housing plate
x 5/8 in.
WARNING
Drycleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel and property.
Wear chemical resistant gloves when using solvents, and avoid repeated or prolonged skin contact.
Do not use near open flame or excessive heat. Flash point of solvent is 100 degrees F to 138
degrees F (38 degrees C to 59 degrees C).
CAUTION
Never use fuel oil, kerosene or other fluids that will leave an oily film on the friction plates.
c.
Cleaning. Clean the clutch assembly and parts with drycleaning solvent.
d.
Inspect. Inspect all parts for wear or damage.
e.
Replace. Replace worn or damaged parts.
f.
Reassembly and Installation of Slip Clutch.
(1)
Install lockring (4, fig. 4-95) on hub (5).
(2)
Slide backplate (7) over hub (5).
(3)
Install one hosing plate (8) and one hub plate (9) and then the other housing plate and hub plate on drive
hub (5).
(4)
Position pressure ring (10) against plate (9) and spring (11) against pressure ring (10), then screw adjusting
nut (12) on drive hub (5). Tighten adjusting nut just far enough to clear groove in drive hub. Install lockring (13) in hub.
(5)
Install key (2) and sprocket (1) on slurry feeder agitator shaft (1, fig. 4-94).
4-195
