TM 55-1930-209-14&P-1
k.
When display page appears on video monitor, take one of these three actions:
(1)
Push keyboard key 1 (prompt ADVANCE CURSOR) to move cursor to select new sensor,
(2)
Push keyboard key 3 (prompt SELECT NEW PAGE) to select a new page,
(3)
Push keyboard key 4 (prompt RETURN TO EDIT MENU) to return to EDIT MENU.
I.
To change reference markers, go to paragraph 8-9.4.2.2
m.
If reference markers are not to be changed, and editing is complete, push EXIT keyboard key to leave
edit mode. Make sure EDIT key goes out and video monitor starts normal scanning of display pages.
8-9.4.2.2 Using EDIT MENU option 1 to change or set reference markers
a.
Press keyboard key 1 (prompt ADVANCE CURSOR) to move cursor to line labeled "REFERENCE
MARKER."
b.
Press keyboard key 2 (prompt EDIT THIS ONE). Make sure prompt display appears on video monitor
and reads as follows:
KEY IN NEW VALUE, THEN PRESS ENTER
RUBOUT - ERASE LAST ENTRY
c.
Using keyboard key, enter new position for reference marker.
NOTES
If mistake is made, correct it before pressing ENTER keyboard key by using
RUBOUT keyboard key. Pressing RUBOUT key causes EMS to backspace and
erase last digit pressed. Further pressing RUBOUT key erases next digit and so
on, until all digits are erased.
If mistake is discovered after ENTRY key has been pushed, mistake is treated like a
normal setting and changed by following procedures in paragraph 8-9.4.2.3.
d.
Correct mistake, if necessary, by using RUBOUT key.
e.
Push ENTER keyboard key. Make sure prompt information changes to the following:
1
-
ADVANCE CURSOR
2
-
EDIT THIS ONE
3
-
SELECT NEW BAR
f.
Repeat steps a thru e for changing reference marks of additional sensors.
g.
When desired reference marks are changed, press EXIT keyboard key to return video monitor to normal
scanning and to leave Edit mode, or press "3" keyboard key (SELECT NEW BAR) to return to display
page.
h.
When display page appears on video monitor screen, take one of these actions:
(1)
Push keyboard key 1 (prompt ADVANCE CURSOR) to move cursor to select a new sensor.
(2)
Push keyboard key 3 (prompt SELECT NEW PAGE) to select a new page.
(3)
Push keyboard key 4 (prompt RETURN TO EDIT MENU) to return to EDIT MENU.
8-21
