TM 55-1930-209-14&P-1
NOTE
If video monitor shows message "MIN=" or "MAX=," allowable range has been
exceeded.
f.
If allowable range has been exceeded, repeat steps c and d; otherwise go to step g.
g.
Repeat steps b thru f until correct date and time is entered in NEW column.
NOTE
With time and date set, with seconds set to zero, clock starts when EXIT keyboard
key is pushed to move video monitor to normal scanning of display pages.
h.
Press EXIT keyboard key to leave edit mode and return EMS video monitor to normal scanning or push
keyboard key 3 (prompt RETURN TO EDIT MENU).
8-9.4.3 Level 2 editing procedures. Select level 2 editing by entering access combination for level 2 edit obtained from
barge master to change display page information. Make sure following EDIT MENU display appears:
EDIT MENU
TO SELECT OPTION, PRESS KEY BELOW NUMBER
1.
EDIT BATR PARAMETERS
2.
EDIT SWITCH PARAMETERS
3.
EDIT TOTALIZERS
4.
EDIT ALARM INHIBITS
5.
SET TIME/DATE
6.
EDIT SCHEDULE LOG
NOTES
·
High and low alarm points are typical data that can be set in level 2.
·
Video monitor displays many items that pertain to general monitoring system
capability and are not part of EMS as used onboard ROWPU barges. Items that
are used onboard have data printed under OLD column; those that do not often
have "N/A" (not applicable) in that column.
a.
Follow procedure for editing level 2 data as used for level 1 in paragraph 8-9.4.1. First select an option
and then follow steps in the prompt shown on video monitor.
NOTE
Time and date can be set either in level 1 or level 2 editing.
b.
To leave edit mode at any time, press EXIT keyboard key.
8-9.5 Edit termination. When editing is to be interrupted or is completed, press EXIT key to return EMS to scanning
video monitor display pages.
8-25
