Section VI. Extended Capabilities
the sensor or Ill to deactivate the sensor, and then press ENTER. The cursor will shorten.
8.
Press EXIT to leave the Edit mode, or press '3' (SELECT NEW BAR) to return to the page
display.
9.
Use the ‘1' key to move the cursor to select a new sensor, the 13' key to select a new
page, or the '4' key to return to the Edit menu.
b)
Set Reference Markers
The operator may set the position of reference markers through the Edit Mode. To set the
position of a reference marker, perform the following steps;
1.
Repeat steps Yl.d.6.a.1 through 5.
2.
Press the '1’
key (ADVANCE CURSOR) to move the cursor to the line labeled
"REFERENCE MARKER".
3.
Press the t2' key (EDIT THIS ONE).
4.
Enter the new position for the reference marker, making sure that the value is within the
MAX/MIN values displayed at the top of the page. Entering a ‘00’ will remove the
reference marker from the bar display.
5.
Press the ENTER key.
6.
Press EXIT to leave the Edit mode, or press '3' (SELECT NEW BAR) to return to the page
display.
7.
Use the ‘1' key to move the cursor to select a new sensor, the '3' key to select a new page,
or the '4' key to return to the Edit menu.
c)
Activate/deactivate Switches
Switches may be activated and deactivated for the same reasons as sensors. Once deactivated,
a switch will be displayed as the switch label with no borders. To activate or deactivate switches,
perform the following steps;
1.
Press 12' (ACTIVATE/DEACTIVATE SWITCHES)
2.
The screen will display the page select prompt. Press the key corresponding to the page
where the switch is located.
3.
The page will be displayed with prompts on the top 2 lines, and the switch closest to the
top left side of the page will be double intensity. Use the '1' key to illuminate the switch
you wish to activate/deactivate. (Note: if the screen flashes and returns to the page select
prompt, there are no switches on the selected page. Either press another page key, or
press EDIT to return to the Edit menu.)
PMS II Operator's Instructions
Page 20
