Section VI. Extended Capabilities
4.
Press '2' (EDIT THIS ONE)
5.
The screen will displayed switch information with the switch label at the top of the pages
and prompts in the upper right corner. The switch number will be displayed as 2 digits:
the first being the switch module number, and the second being the position of that switch
on the switch module. The cursor will be on the line 'SWITCH ACTIVE'.
6.
Press '2' (EDIT THIS ONE)
7.
The cursor will extend. Enter ‘1' to deactivate the switch, or '0' to activate it. Then press
the ENTER key.
8.
Press the EXIT key to leave the Edit mode, or press '3' (SELECT NEW SWITCH) to return
to the page display.
9.
Use the '1’ key to select a new switch, the '3' key to select a new page, or the '4' key to
return to the Edit menu.
d)
Activate/Deactivate/Preset Totalizers
Totalizers are counters (like the odometers on a car) that display up to 8 digits. They are used to
monitor fuel consumed, engine hours, and other similar functions. Totalizers can be activated,
deactivated, or preset to a number to start counting from, by using the Edit mode. To set a
totalizer, perform the following steps;
1.
Press '3' (ACTIVATE/DEACTIVATE/PRESET TOTALIZERS)
2.
The screen will display a page select prompt. Press the key corresponding to the page
where the totalizer is located.
3.
The screen will display the monitoring page with prompts on the top 2 lines and the
totalizer display closest to the top and the left side illuminated. Use the '1' key (ADVANCE
CURSOR) to illuminate the totalizer you wish to set. (Note: If the page flashes, and
returns to the page select prompt, there are no totalizers on the selected page. Either
select a new page, or press the EDIT key to return to the Edit menu.)
4.
The screen will display the totalizer information, with the totalizer label at the top and
prompts in the upper right corner. The cursor will be on the line with 'TOTALIZER
ACTIVE'.
PMS II Operator's Instructions
Page 21
