MARCH 1984
INSTRUCTION MANUAL #282A
BALDOR
DUST CONTROL ACCESSORY - SERIES "A"
INSTALLATION INSTRUCTIONS
Fig. A.
Fig. B.
Fig. C.
CAUTION:
FOR YOUR OWN SAFETY, READ AND
UNDERSTAND
INSTRUCTIONS
BEFORE PROCEEDING:
1.
Pedestal must be bolted securely to the
floor before Installation of dust control
accessory unit and grinder.
CAUTION:
MOUNTING
DUST
CONTROL
UNIT
BEFORE
BOLTING
PEDESTAL
TO
FLOOR MAY CAUSE PEDESTAL TO TIP
OVER.
2.
Remove pedestal assembly bolt (Fig. A)
located in top mounting plate.
3.
Replace pedestal assembly bolt with stud
and washers supplied with dust control
accessory unit. (Fig. B) NOTE: #1-B for
GA20 pedestal, #2-B for GA16 pedestal
Tighten stud securely into pedestal.
4.
Mount dust collector bracket over stud
with motor on bottom side. (Fig. B) Align
mounting holes in bracket with those in
pedestal. Secure bracket to stud with nut
supplied. Proceed to mount grinder to
pedestal by locating proper holes and
installing
grinder
to
pedestal
with
mounting bolts supplied.
5.
Mount double-inlet air control valve to Inlet
of blower unit and secure at base of air
control valve. Attach a hose to each inlet
and to each grinder exhaust outlet.
Secure hoses with clamps supplied.
6.
Attach elbow to exhaust outlet and attach
bag with clamp supplied (Fig. C).
BALDOR
PHONE 501-646-4711
TELEX 53-7425 - TWX 910-
723-7650
FORT SMITH, ARKANSAS
72902
