TM 55-1930-209-14&P-19 Table 15-1.  Preventive Maintenance Checks and Services for Miscellaneous Equipment (Continued) B - Before D - Daily Q -  Quarterly D - During W - Weekly S -  Semiannually A - After M - Monthly A -  Annually INTERVAL ITEM PROCEDURES EQUIPMENT ITEM TO BE CHECK FOR AND HAVE IS NOT READY/ NO. INSPECTED REPAIRED OR ADJUSTED AVAILABLE IF B   D   A   D  W  M   Q   S   A AS NECESSARY 3) Clean basket as follows: CAUTION Do NOT use any petroleum based products to clean basket.  Be careful not to damage basket.  Do not use wire brush. - On weatherdeck, clean basket with soft brush and flush with drinking water. - Use compressed air to dislodge dif- ficult particles. - Flush with drinking water. - Wipe interior of basket with clean cloth before replacing basket. 4) Lower basket into well. 5) Swing yoke over basket well until end fits over stud. 6) Check O-rings on cover.  Replace if damaged. 7) Be sure O-rings on cover rest in machined groves before tightening yoke screw securely.  Do NOT over- tighten. • • e.     Check that foot valve is not clogged. Clean if necessary. •  •  • f.   Inform shift leader of unusual noises or Bilge pump motor overheating of bilge pump motor which overheating. may indicate a pending malfunction. • g.     Log and repart all corrective actions taken and their locations to shift leader. • • h.     Remove rust and corrosion.  Touch up paint in accordance with TB 43-0144 as necessary.  Do not paint threads or labels. 15-12