DECKMASTER
TABLE 8.5
PROTECTIVE COATING SPECIFICATIONS
PAINTING PROCEDURE
1.0.
Inspection
1.1
Prior to the beginning of any abrasive blasting, all surfaces will be inspected by Brancart Development personnel
as to its acceptability for proper coating. Should any areas be deemed unsatisfactory, they shall be identified,
marked. and held for action determined by the owner or his designated representative.
2.0.
External Surfaces
2.1.
Surface Preparation
2.1.1 Prior to abrasive blasting, the steel shall be examined for the presence of any oils or greases. Should any
be present, it shall be removed by use of a volatile non-oily solvent and clean rags-
2.1.2 Surfaces not to be blasted will be protected by appropriate masking.
2.1.3 All surfaces shall be abrasive blasted to a near-white metal finish (SSPC-SP10-63T or NACE 2).
2.1.4 All blasted surfaces shall be primed the same day.
2.2
Protective Coating Application - Abrasive Blasted Surfaces
2.2.1 Apply one coat of Inorganic Zinc to a dry film thickness of 2½ - 4 mils DFT.
8-20
