CONTROL ADJUSTMENTS
8.
With a 1/8" internal hex wrench, slowly turn the
neutral adjustment screw CW until charge
pressure begins to decrease. Then slowly turn
the adjustment screw CCW, while counting the
turns. until charge pressure decreases again
(charge pressure will rise in neutral and drop
when going into stroke).
9.
Turn the Adjustment screw CW half the amount
of
turns
counted.
This
should
be
the
approximate center of neutral.
10.
Install the hex head plug assembly and torque
to 30-40 ft. lbs.
NOTE
If a motor is used which does not
have a manifold, adjust neutral
(Steps 8-10) by observing the motor
output shaft rotation without load.
Page 21