WOODWARD PSG GOVERNOR
TESTING ANG ADJUSTING
DIAL INDICATOR INSTALLED
7. 6V3075 Dial Indicator.
5.
Move governor drive lever (8) to the FUEL OFF
position (rotate lever clockwise).
GOVERNOR DRIVE LEVER
8. Lever.
6.
Hold lever (8) in the FUEL OFF position and set
dial indicator (7) to zero.
7.
Turn lever (8) slowly in the FUEL ON direction
(counterclockwise) until it stops.
8.
Read the measurement on the dial indicator.
See the FUEL SETTING AND
RELATED
INFORMATION FICHE for the correct static fuel
setting.
9.
If the measurement is not correct do the steps
that follow:
a.
Remove cover (9) and the washer (12).
b.
Loosen nut (I I ) until lock (14) is free of
the pin (13).
c.
screw (10).as necessary. to get the
correct reading on the dial indicator.
Remember to turn governor drive lever (8)
counterclockwise when reading the dial
indicator.
GOVERNOR DRIVE GROUP
9. Cover. 10. Screw. 11. Nut. 12. Washer. 13.
Pin. 14. Lock.
NOTE: Turn screw (10) clockwise to decrease or
counterclockwise to increase the fuel setting.
NOTE: If pin ( 13) is not in alignment with one of the
notches in lock (14), turn screw (10) to put the nearest
notch in alignment with the pin.
d.
Tighten nut (I I). Check the adjustment b!
going through Steps 5 through 9 again
When the adjustment is correct, install
washer (12) and cover (9).
ADJUSTING THE HIGH IDLE STOP
1.
Start the engine and let it run until the coolant
temperature is normal.
2.
Loosen locknut (3). Turn stop screw (4)
counterclockwise approximately two turns.
NOTICE
With the stop screw in this position the engine can
overspeed. This can cause damage to engine
components. Be ready to shutdown the engine if it
has an overspeed condition.
3.
Use knurled knob (2) or synchronizing motor (1)
to adjust the engine to the desired speed.
4.
Turn stop screw (4) clockwise until it stops.
Tighten locknut (3).
5.
If the engine speed is still correct. the
adjustment is correct.
61
