Engine
Disassembly and Assembly
Oil Filter And Oil Filter Base
Remove Oil Filter And Oil Filter Base
1318 & 1306-011
Tools Needed
A
2P8250
Strap Wrench
1
1. Remove the oil filter from oil filter base (1) with tool
(A).
2. Remove the bolts that hold clip (5) and tube assembly
(3) to the engine. Remove the gasket and tube
assembly. Remove the 0ring seal from tube assembly
(3) if necessary.
3. Remove the bolts that hold tube assembly (4) to the
engine. Remove tube assembly (4) and the gasket.
Remove the O-ring seal from tube assembly (4) if
necessary.
4. Remove four bolts (2) and oil filter base (1) from the
engine.
5. Remove the two O-ring seals from the top of the oil
filter base if necessary.
Install Oil Filter And Oil Filter Base
1318 & 1306-012
1. Put clean engine oil on the two O-ring seals that go
between the oil filter base and the oil cooler. Put the O-
ring seals in position on the top of oil filter base (1). Put
oil filter base (1) in position on the engine oil cooler, and
install bolts (3) to hold it.
2. Install the O-ring seal on tube assembly (4), and put
clean engine oil on it. Put the gasket and tube assembly
(4) in position as shown, and install the bolts that hold it.
3. Install the O-ring seal on tube assembly (2), and put
clean engine oil on it. Put the gasket, tube assembly (2)
and clip (5) in position as shown, and install the bolts that
hold them.
4. Put clean engine oil on the oil filter seal, and install it
by following the instruction procedure on the oil filter.
44
