Engine
Disassembly and Assembly
Exhaust Manifold (3306)
Remove And Install Exhaust Manifold (3306) 1059-
010 START BY: a.
remove turbocharger b. remove
fuel
injection
lines
1.
Remove bolt (3) and the nut from the front cover.
2.
Remove the nuts, washers and shield (2).
Remove spacers (1) and (6) from behind the shield.
3.
Remove nuts (5) and the washers that hold the
exhaust manifold in position. Remove exhaust manifold
(4) and the gaskets.
4.
If it was necessary to remove the studs, put 5P3931
Anti-Seize Compound on the threads that fit into the
cylinder head. Install the studs and tighten them to a
torque of 27 + 4 N-m (20 + 3 Ib.ft.).
5. Put 5P3931 Anti-Seize Compound on the threads of
the studs. Put the gaskets and exhaust manifold (4) in
position on the studs.
Install the washers and nuts (5) on all the studs except
the front one and the eighth one from the front.
6.
Install the washer and short spacer (6) on the eighth
stud from the front. Put the washer and long spacer (1)
on the front stud. Put shield (2) in position as shown, and
install the washers and nuts that hold it.
END BY:
a.
install turbocharger
b.
install fuel injection lines
49
